Installation

The Installation Process

1. Once you have placed an order with us we will schedule an installer to come to your home or business.
2. Once the installer arrives he will conduct a site survey to confirm that signal is available to your residence.
3. The installer will then discuss with you where the antenna must be placed to obtain service.
4. The antenna will then be mounted on the roof of your home.
5. A cable will be run from the antenna and is terminated to the VABB subscriber unit in your home.
   Note: The standard installation does not include any in-building cabling, wall fishes or trenching. We can arrange for a custom installation at an additional charge.
6. The connection is then tested by your installer at the Subscriber Unit and at your computer to ensure the Internet is functioning properly

What we provide:

1. An antenna will be mounted on your roof or the best location for signal reception

   We have 2 types of antennas that are used in the installation process.

   • A yagi antenna
     
     We use this type of high performance antenna for most of our installations. It allows a greater gain of radio signal.
   • A flat panel antenna
     
     This type of antenna is used when the radio signal strength from your broadcaster is very strong. Up to 75 feet of CAT 5/Ethernet cable will run from the antenna to the inside of home or business
2. Subscriber Unit that will connect to your wireless router
   or directly to your ethernet port.
   
   Wireless routers provide a convenient way to connect a small number of wired and any number of wireless computers to the Internet.
   
   Ethernet Port: This is also know as a RJ45 jack
   it is wider than a telephone jack
   
   Subscriber Unit
3. Labor and Survey